Rough Country 276P - Manual (Page 6)

26. Using a 21mm wrench and socket remove the upper bolt that holds the differential. Remove the differential from the
vehicle. Do not remove the passenger side differential bracket from the axle. The new drop brackets will attach to
the stock differential bracket.
27. Using a reciprocating saw cut the driver side lower differential mount off. See Photo 17 & 18.
28. Using a grinder, trim down the fins on the drivers side of the differential as shown in Photo 19. Start by trimming
about a 1/4”, then trim to fit.
29. Using a 10mm socket remove the bolts holding the sway bar to the frame. Invert the sway bar where the ends will be
pointed downward, and reinstall using the 10mm socket and stock hardware.
30. Using a 13mm socket remove the factory bump stop from the bracket. Retain for later use. Using the reciprocating
saw, remove the bump stop from the frame on the driver and passengers side. See Photo 20.
31. Grind the bump stop mount down flush with the frame. See Photo 21.
Photo 17 Photo 18
Photo 19 Photo 20
Photo 21