Rough Country 276P - Manual (Page 7)

32. Place the driver side upper control arm drop bracket from 1274 Box 2, into the stock upper control arm brackets as
seen in Photo 22 & 23. Bolt in place using (2) 9/16” 3 1/2” bolts, 9/16” nuts and 2-flat square washers from 1274Bag 7
on the inside of the stock mount as shown in Photo 23.
33. Place the passengers side upper control arm drop bracket from 1274 Box 1, into the stock upper control arm bracket.
Bolt in place using (2) 9/16” 3 1/2” bolts, 9/16” nuts and 2-flat square washers from 1274Bag 7.
34. Locate the driver and passenger side torsion bar drop brackets in 1274 Box 2. Position the two drop brackets in
between the bottom of the frame and the top of the cross member. Using the (2) stock bolts and (1) 7/16” x 1 1/4” bolt,
washers and lock nut from 1274Bag4, bolt the drop brackets to the bottom of the frame rail. Torque to 60 ft/lbs.
35. If installing on a 4DR Tahoe or 4DR Yukon, please use the installation instructions supplied with the 89501 that was
ordered separately. The part # 89501 must be used for the 4DR Tahoe & Yukon.
36. Bolt the stock torsion bar cross member to the bottom of the new torsion bar drop bracket. Using (2) 7/16” x 1 1/4” bolt,
washers and lock nut from 1274Bag4, and one stock bolt. Torque to 60 ft/lbs.. See Photo 24.
36. Locate the front cross member from 1274 Box 3. Hang the front cross member in the lower control arm pockets with
the large hole and the four holes in the bottom of the cross-member to the front. Use the stock bolts with head of the
bolt pointing toward the rear and the threads to the front. This is done for clearance on the steering link. See Photo 25.
37. Locate the rear cross member from 1274 Box 3. Using a 13mm wrench and stock hardware install the stock bump stop
on the lower mount of the rear cross member. Locate the bump stop from 1274bag2. Bolt the upper bump stop on the
top of the rear cross member using a 9/16” wrench and suppled 3/8” nuts & washers from 1274bag2. Hang the rear
cross member in the lower control arm pockets using the stock bolts. See Photo 26.
38. Locate the 2 differential brackets from 1274 Box 2. Bolt one bracket to the top mount of the differential as shown in
Photo 27, using the 9/16” x4” bolts, washers and nuts provided in 1274bag3. Torque to 95 ft/lbs.
Photo 22 Photo 23
Photo 24 Photo 25
Photo 26 Photo 27