Cleaning and oiling the banks ram-air filter – Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) PowerPack & Stinger systems '01-04 Class-A MH, P-series User Manual

Page 13

Advertising
background image

notification

The banks ram-air Filter

comes pre-oiled and no

oiling is necessary for initial

installation. use banks ram-air

Filter cleaning system (part#

90094), available from gale

banks engineering to service

the air Filter. Follow the

instructions included with the

cleaning system to clean and

re-oil your banks ram-air Filter.

1. PRE-

CLEANING

Tap the element

to dislodge any

large embedded

dirt, then gently

brush with a soft

bristle brush.

NOTE: If complete

cleaning is not practical at this

time, reoil the element and

reinstall in your vehicle.
2. SPRAy-oN CLEANING

Spray Banks air-filter cleaner

liberally onto the entire

element and let

soak for 10

minutes.

PAN

CLEANING

Large

air-filter

elements can

be rolled or

soaked in a

shallow pan

of Banks air-

filter cleaner.

Remove

immediately and let soak for

approximately 10 minutes.
3. CLEANING hINtS

Use only Banks air-filter

cleaner. No gasoline cleaning,

No steam cleaning, No caustic

cleaning solutions, No strong

detergents, No high-pressure

car wash, No parts cleaning

solvents. Any of these No’s

can cause harm to the cotton

filter media plus SHRINK and

HARDEN the rubber end caps.
4. RINSE off

Rinse off the element with

low-pressure water. Tap water

is okay. Always flush from the

clean side to dirty side. This

removes the dirt and does not

drive it into the filter.

5. dRyING hINtS

always dry naturally. after

rinsing, shake off all excess

water and let the element

dry naturally. DO NOT USE

cOMPRESSED aIR – DO

NOT USE OPEN FLAME – DO

NOT USE HEAT DRYERS!

EXCESS HEAT WILL SHRINK

THE COTTON FILTER MEDIA.

cOMPRESSED aIR WILL BLOW

HOLES IN THE ELEMENT.
6. AERoSoL oILING

after cleaning air filter always

reoil before using. Spray Banks

Ram-air filter oil down into

each pleat with one pass per

pleat. Wait 10 minutes and

re-oil any white spots

still showing.

7. oILING hINtS

Never use a Banks Ram-air

filter without oil (the filter

will not stop the dirt without

the oil). Use only Banks Ram-

air filter oil. Banks air-filter

oil is a compound of mineral

and animal oil blended with

special polymers to form a

very efficient tack barrier.

Red dye is added to show just

where you have applied the

oil. Eventually the red color

will fade but the oil will remain

and filter the air. NEVER USE

Automatic Transmission Fluid.

NEVER USE Motor Oil. NEVER

USE Diesel Fuel. NEVER USE

WD40, LPS, or other light-

weight oils.
8. REINStALL

Reinstall your Banks Ram-air

filter element with proper

care. Make sure the element

seats properly in the filter

case. Install the cover making

sure it’s in the right position.

Tighten all the nuts, bolts,

screws or clips to factory

specifications.
9. do Not dISCARd

Affix the “Do Not Discard”

sticker to the filter case

(included with every Banks

replacement element). Make

sure you put the sticker in a

highly visible place to alert

your mechanic not to discard.
10. PERfoRMANCE hINtS

Service every 50-100,000

miles on street-driven

applications. Service more

often in offroad or heavy-

dust conditions. If an air-filter

restriction gauge is installed,

then change the element

when the air-filter restriction

reaches 18”–H2O.

CauTion!

extremely fine dust

from agriculture or offroad

use will pull the oil from the

element. Frequent reoiling of

the element’s clean side might

be required. Completely service

when practicable. For extra

protection use an air-filter

sealing grease on rubber ends

of the element. service only

with banks air-filter cleaner

and banks air-filter oil.

Cleaning and oiling the banks ram-air Filter

9 6 4 3 2 v . 5 . 0

| 13

Advertising