Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) PowerPack & Stinger systems '01-04 Class-A MH, P-series - Manual (Page 6)

starter cable to other cables
in the area and reinstalled the
cable and retaining nut to the
starter.
12.
If the starter cable runs
from the rear of the motor
home install the 90-degree
terminal end of the supplied
starter cable extension onto
the starter motor and tighten
the retaining nut. Route
the starter cable extension
forward through the frame rail
under the cross member then
back over the cross member
to the starter motor and at
least 6” away from all heat
sources as shown in Figure
2 .
Slide the 4-inch length of heat
shrink over the extension.
Attach the extension to the
factory starter cable using:
(1)
5 ⁄
16
-18 x 1 ⁄
2
” bolt
(1) 5 ⁄
16
-18 crimplock nut
(1) 5 ⁄
16
SAE washer
Slide the heat shrink over
the bolted starter cable
connection and heat with
a heat gun until the heat
shrink tightly conforms to
the connection. Make sure
the connection is completely
covered.
13.
On the driver-side of
the engine block, remove
the knock sensor heat shield
located just below the
exhaust ports next to the
oil filter. Install the supplied
heat shield onto the factory
location using the factory
hardware (see Figure
3 ).
14.
Inspect the exhaust
mounting surfaces of
the cylinder heads and
remove any rust or carbon,
which would prevent the
TorqueTube manifolds from
sealing. Tie cables away
from left-side Torque Tube as
shown in Figure
4 .
Note: Do not use the factory
exhaust manifold gaskets
upon reinstallation. Banks
Figure 3
Figure 2
6 |
9 6 4 3 2 v . 5 . 0