Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) PowerPack & Stinger systems '01-04 Class-A MH, P-series User Manual
Page 7
TorqueTube manifolds are
a machined surface and are
designed to seal without
gaskets.
15.
On the passenger side
of the vehicle, bend the lower
right corner of the driver-side
starter heat-shield downward
for TorqueTube clearance
(see Figure
5
). Connect the
supplied heat-shield and
#36 hose clamp to the brake
reservoir on the vehicle’s
driver side (see Figure
6
).
Route the hose clamp to the
inside of the brake reservoir
and tighten the hose clamp
with a standard screwdriver
until the heat-shield is
securely supported.
16.
apply a small amount of
anti-seize onto the threads of
the supplied 8 mm manifold
bolts. Lift the right side
TorqueTube manifold into
place and install an 8 mm x 25
mm bolt at the front and rear
of the TorqueTube to hold it in
place. Set the (slightly longer)
single 8mm x 30 mm bolt
aside and install the remaining
8 mm x 25 mm manifold bolts
to secure the TorqueTube.
Repeat this step for the left
side TorqueTube.
Note: Do not install a
manifold bolt in the bolt hole
used to mount the dipstick
tube bracket. Torque all
manifold bolts to 26 ft-lbs.
Figure 5
Figure 6
Figure 4
9 6 4 3 2 v . 5 . 0
| 7