Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Intake- High-Ram Intake '03-07 w_Banks Boost Tube User Manual
Page 10
10
96425 v.2.0
16.
Slide the second provided intake
gasket over the four studs and set the
High-Ram in place on the studs. Twist
a Stat-o-seal washer over the outer
two studs, then over each stud install
a flat
5
⁄
16
” AN washer. Install a
5
⁄
16
-24
nylock nut on each stud and tighten all
four evenly between 140 to 150 lb-in.
See Figure 7.
CAuTIoN: use only handtools
when tightening the High-
Ram. Tighten snugly but do not
overtighten. Damage to the
High-Ram casting can result from
the use of pneumatic tools or
excessive tightening.
17.
Place the supplied spacer on
the stud on the High-Ram. Mount the
bracket on the MAP and FRP wire
harness to the stud, and secure the
bracket with the original washer and
nut that were removed in Step 3.
18.
The plastic pin on the heater wire
harness will not be used to secure to
the High-ram. Use a supplied cable tie
to secure the harness away from any
heat source.
19.
Remove all rags from the boost
tube opening and reconnect the
rubber hose from the boost tube to
the High-Ram and tighten the clamp
to 100 lb-in (11 N-m).
20.
Rotate dipstick bracket and align
the dipstick bracket hole to the hole
on the High-Ram. Mount it to the
High-Ram casting using the original
factory bolt. See Figures 7 and 8.
NOTE: For 2004-2007 model vehicles,
locate the supplied corrugated loom
in your kit and install over the main
connector wires to protect it from
rubbing against the dipstick. See
Figure 9.
21.
Reconnect the batteries. The
Banks High Ram installation is now
complete.
Figure 7