Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Intake- High-Ram Intake '03-07 w_Banks Boost Tube - Manual (Page 5)

96425 v.2.0
5
SToCK INTAKe eLBoW
AND BooST TuBe
ReMoVAL
1.
Loosen the clamps that hold the
rubber hose at the inlet of the stock
intake elbow and slide the hose free of
the intake inlet.
CAuTIoN: Cover the intercooler
up-pipe opening with a clean rag
to prevent foreign objects from
entering the intake tract.
2.
Remove the bolt that holds the
dipstick on the intake elbow. Save the
bolt for reuse. Gently push and move
the dipstick and its holder to the rear
of the engine compartment to gain
access to the engine.
3.
Remove the electric heater wire
harness from the stock intake elbow
by pulling the plastic pin out. Remove
the wire harness brackets that are
mounted on the intake by removing
the nut and the washer. Save the nut
and the washer for re-use.
4.
Unbolt and remove the 4 bolts at
the base of the stock intake elbow
and remove the intake elbow from
the engine, being careful to not knock
any debris into the intake through the
electric heater element block.
5.
Remove the stud bolt from the
stock intake elbow (see Figure 2), and
install it onto Banks High-Ram at the
same location.
6.
Remove the wires connecting the
electric heater element block to the
engine and remove the heater element
block. Save the fasteners for re-use.
CAuTIoN: Cover the opening in the
intake manifold with a clean rag
to prevent foreign objects from
entering the engine.
Figure 1 2007 Model Stock Intake Elbow Shown