Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '08-10 Compatible with PowerPDA User Manual
Page 15
96827 v.6.0
15
Figure 10: SpeedBrake and supplied wiring harnesses
6.
Locate the Banks Brake Wire
Harness and connect the 2-pin male
connector on the Brake Pressure
Sensor harness to the 2-pin connector
on the Banks Brake wire harness.
If you have previously installed a
PowerPDA or Banks iQ, continue to
Step 7.
If you have not previously installed a
PowerPDA or Banks iQ, skip to Step
10.
Removing a Previously installed
Banks OBD II Interface Cable
7.
Disconnect Banks OBD II interface
cable from the vehicle OBD II
connector.
A. For PowerPDA: Disconnect the
RJ12 connector from the docking
station.
B. For Banks iQ: Disconnect the
RJ12 connector from the Banks iQ
Bridge Module.
8.
Disconnect the 8-pin connector
from the OBD II interface cable from
the 8-pin connector on the Six-Gun in-
cab cable.
9.
Remove the OBD II interface cable
from the vehicle.