Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '08-10 Compatible with PowerPDA User Manual
Page 8
8
96827 v.6.0
Section 1
INSTALLATION OF BANKS SIX-GUN WIRING HARNESS
Figure 1: Six-Gun and supplied wiring harnesses
If you have previously installed a
Six-Gun and are adding the Banks
Brake, Skip to Section 2.
If you are installing the Banks Six-
Gun for the first time, continue to
Step 1
Six-Gun Installation
1.
Locate the Six-Gun Powertrain
control Module (PcM) Harness. See
Figure 1. Place harness over the
driver side fuse box. Route the PCM
connectors from the driver side fuse
box along the rail on the rear of the
engine compartment to the passenger
side of the vehicle. See Figure 2.
2.
Locate the Factory Powertrain
control Module (PcM) on the
passenger side firewall in the engine
compartment. See Figure 2.
3.
Disconnect the left connector from
the PcM by opening the locking tab as
shown in Figure 3.
4.
Insert the male connector on the
Six Gun Tuner PCM harness into the
female connector on the factory
harness. Insert the female connector
on the Six Gun Tuner PCM harness
onto the male connector on the
factory PcM. Lock the connection by
closing the locking tabs. Secure the
connectors behind the oil reservoir
and away from any heat source.
5.
Secure the Six-Gun Tuner PCM
harness along the rail on the firewall
with the supplied cable ties.