Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '08-10 Compatible with PowerPDA User Manual
Page 23
96827 v.6.0
23
Figure 20 Banks Bridge Module
and connect it to the USB receptacle
on the left side of Banks iQ. See
Figure 16. Snap the fuse access panel
back in place making sure not to pinch
the wire.
WARNING: THE CHARGING CABLE
CONNECTED TO THE BANKS iQ IS
DESIGNED TO SUPPLY A CONSTANT
LOW-VOLTAGE POWER SOURCE
(+5VDC) TO THE BANKS iQ AND IS
“LIVE” AS LONG AS THE SYSTEM’S
OBD II INTERFACE CABLE OR BANKS
WIRING HARNESS IS COMPLETELY
INSTALLED AND THE USB CABLE
CONNECTOR IS PLUGGED INTO
BANKS iQ. ALTHOUGH THIS
CHARGING CABLE IS SHORT AND
ITS CIRCUITRY IS FUSE-PROTECTED,
THE USER IS EXPECTED TO TAKE
APPROPRIATE MEASURES TO
PREVENT SMALL CHILDREN AND/
OR PETS FROM CONTACT WITH ANY
PART OF THIS SYSTEM.
12.
Secure Banks iQ Bridge Module
under the dash to any dash frame
support using the supplied cable ties.
Use the cable tie support loops on the
side of the Bridge Module to securely
fasten it under the dash.
13.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure the
wiring under the dash.
14.
Reinstall the lower knee panel
back in place with the factory
hardware. Tuck any excess cable
behind it for a clean appearance.
-END, SEcTION 3-