Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Power Systems- PowerPack & Stinger Systems w_ EconoMind (LB7 & LLY) '01-05 (iQ) Compatible with Optional Banks iQ - Manual (Page 19)

96814 v.2.0
19
RAM-AIR INSTALLATIoN
Use the Bill of Materials Chart and
the General Assembly Drawing to
reference component nomenclature
and location. See Figure 23. Use
caution when working in the engine
compartment. Make sure the engine
has been OFF for several hours and
cool. Make sure to complete
Steps 1 thru 3 of Section 2 before
proceeding.
2001 thru 2004 LB7 Duramax engine
1.
You will have either a decorative
cover or a resonator covering the
intake manifold. The decorative cover
may need to be removed in order to
facilitate installation and alignment
of the Banks Ram-air intake system.
Remove the decorative cover by
removing the screw securing the
rubber grommet. Once the rubbe
grommet is removed, lift up and
unhinge the decorative cover from
its mount. Reinstall decorative cover
after the installation of the Banks
Ram-air system is complete. See
Figure 24.
If you have the resonator with
attached decorative cover then the
resonator and attached decorative
cover will be removed from the
engine and will not be used in
conjunction with the Banks Ram-Air
intake system. See Figure 25.
2.
Locate your Banks Ram-Air filter
housing from your kit and install as
shown in Figure 26. The cutout on
Banks Ram-Air filter housing must
face passenger side fender. Align
the Banks Ram-Air filter housing
holes with bolt holes in engine
compartment. Install the previously
removed stock air box bolts to
secure the Banks Ram-Air filter
housing. Do not tighten the bolts at
this time.
3.
Locate your Banks Torx tool,T20H
in your Banks Ram-Air kit. Use the
Torx tool bit to remove the two (2)
screws securing the MAF sensor to
the stock air box cover.
Note: When removing the MAF
sensor, grasp its body and pull up
and out. Do not twist or bend when
removing.
Figure 26
Figure 25
Figure 24