Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Power Systems- PowerPack & Stinger Systems w_ EconoMind (LB7 & LLY) '01-05 (iQ) Compatible with Optional Banks iQ User Manual

Page 26

Advertising
background image

26

96814 v.2.0

7.

Locate the Banks OBD II Interface

Cable in your kit. This cable has

three connection points. Connect

the RED OBD II connector on the

Banks interface cable to the vehicle

OBD II connector. Use a cable tie as

shown in Figure 41 to secure the

Banks interface cable to the vehicle

OBD II connector. Next, connect the

6-pin connector on the Banks OBD II

interface cable to the 6-pin connector

on the EconoMind Tuner harness.

8.

Locate the RJ12 Cable (similar to

telephone connector) on your Banks

OBDII interface cable

. See Figure 42.

9.

Locate Banks iQ Bridge Module and

connect the RJ12 connector into the

Bridge Module. See Figure 43.

10.

Route the Banks iQ USB interface

cable from the Banks iQ Bridge Module

under the dash and out through the

fuse access panel opening. The cable

can be slid under the door frame’s seal

and run up to the top of the dash. Pull

enough cable to reach the Banks iQ

and connect it to the left receptacle on

the iQ. See Figure 40. Snap the fuse

access panel back in place making sure

not to pinch the wire.
WARNING: THE CHARGING CABLE

CoNNECTED To THE BANkS

IQ IS DESIGNED To SuPPLy

A CoNSTANT LoW-VoLTAGE

PoWER SouRCE (+5VDC) To

THE BANkS IQ AND IS “LIVE”

AS LoNG AS THE SySTEM’S

oBD II INTERFACE CABLE oR

BANkS WIRING HARNESS IS

CoMPLETELy INSTALLED AND

THE uSB CABLE CoNNECToR

IS PLuGGED INTo BANkS IQ.

ALTHouGH THIS CHARGING CABLE

IS SHoRT AND ITS CIRCuITRy IS

FuSE-PRoTECTED, THE uSER IS

ExPECTED To TAkE APPRoPRIATE

MEASuRES To PREVENT SMALL

CHILDREN AND/oR PETS FRoM

CoNTACT WITH ANy PART oF THIS

SySTEM.

11.

Secure Banks iQ Bridge Module

under the dash to any dash frame

support using the supplied cable ties.

Use the cable tie support loops on the

side of the Bridge Module to securely

fasten it under the dash.

12.

Route all wiring away from any

pedals or other moving components.

Using the cable ties supplied, secure

the wiring under the dash.

-END, SEcTION 6-

Figure 41

Figure 42 Banks iQ System

Figure 43 Banks Bridge Module

Advertising