Banks Power Ford Motorhomes: (Gas ’05 - 14 6.8L V-10, Class-A (30-valve) Intake- Ram-Air Intake System, (Class-A) '06-08 - Manual (Page 11)

11.
From the previously removed
stock air housing, carefully remove the
MAF sensor from the housing cover.
12.
Remove the factory MAF sensor
gasket. Locate and install the supplied
Banks MAF sensor gasket onto the
sensor. NOTE: Make sure to line up
the gasket. The gasket only fits on one
way. See Figure 9.
13.
Install the MAF sensor into the
Banks intake tube. See Figure 10.
14.
Assemble the supplied Banks
intake tube hose and hose clamps
onto the Banks front intake tube.
Tighten the hose clamp to the front
intake tube.
15.
With the Banks intake tube fully
assembled, install it into the engine
compartment. Connect the Banks
throttle body hose to the throttle
body and tighten the hose clamp. See
Figure 11.
16.
Connect the PCV valve tube to the
port on the Banks rear intake tube.
INSTALL BANKS RAM-AIR
FILTER HOUSING
17.
Locate the supplied Banks Ram-
Air Filter Housing, Banks Ram-Air Filter
Element, and hose clamp. Install the
hose clamp onto the Banks air filter.
NOTE: Do not tighten the hose clamp
onto the air filter at this time. Leave
loose to fit Banks air filter cover in a
step 21.
Figure 10
96380 v.4.0
11