Banks Power Ford Motorhomes: (Gas ’05 - 14 6.8L V-10, Class-A (30-valve) Intake- Ram-Air Intake System, (Class-A) '06-08 User Manual
Page 6
REMOVE STOCK
AIR FILTER SYSTEM
You are about to install the Banks
Ram-Air Intake System. Read and
follow all steps before working on the
vehicle. Some components from the
stock air intake system will remain
in service. Take care when removing
stock air intake components to not
damage them.
Use the Bill of Materials Chart and
the General Assembly Drawing to
reference component nomenclature
and location. Use caution when
working in the engine compartment.
Make sure the engine has been OFF
for several hours and cool.
1.
Gain access to the front of the
engine compartment. Locate the stock
air filter housing.
2.
Locate and remove the Mass
Air Flow (MAF) sensor connector.
See Figure 2. Loosen the air filter
housing intake hose clamp. Remove
the air filter housing from the engine
compartment and set aside. NOTE:
There may be slight resistance when
removing the air filter housing from
the rubber grommets. Take care not to
damage equipment or sensors when
removing the housing. See Figure 3.
3.
Remove the (2) rubber grommets
from the air filter housing tray. See
Figure 4. Reinstall the grommets to
the vertical housing filter panel. See
Figure 5.
Section 2
RAM-AIR INSTALLATION
Figure 2
6
96380 v.4.0