Banks Power Ford Motorhomes: (Gas ’05 - 14 6.8L V-10, Class-A (30-valve) Intake- Ram-Air Intake System, (Class-A) '06-08 - Manual (Page 13)

Figure 16
18.
Place the filter and hose clamp
into the Banks Ram-Air Filter Housing.
19.
Install the Banks air filter housing
into the stock air filter tray. NOTE:
Insert the housing with opening facing
away from the engine, then twist
in towards the passenger side. See
Figures 12,13,14 and 15.
20.
Using the supplied Banks air
filter housing hardware, slide the lock
washer and then the large flat washer
over the screw. Install the screw from
the bottom of the stock housing tray
into the Banks housing (Figure 16).
NOTE: Hand tighten with screw driver
only.
21.
Place the Banks air filter cover
onto the Banks air filter housing. Install
the Banks filter onto the Banks cover
and tighten the hose clamp as shown
in Figure 17.
22.
Slide the Banks intake hose onto
the Banks air filter cover and tighten
the hose clamp. See Figure 18.
23.
Install the supplied screws
into Banks Ram-Air Filter Cover and
tighten. NOTE: Hand tighten with
screw driver only.
24.
Re-attach the MAF sensor
connector to the MAF sensor.
25.
Reconnect the battery ground.
Make sure to go over all hose clamps
for tightness and connectors for a sure
fit.
Make sure that the intake tube is not
touching any engine components.
Enjoy your Banks Ram-Air Filter
System.
The installation of the Banks Ram-Air
Intake System is complete.
96380 v.4.0
13