Banks Power Ford Motorhomes: (Gas ’05 - 14 6.8L V-10, Class-A (30-valve) Intake- Ram-Air Intake System, (Class-A) '06-08 - Manual (Page 9)

Figure 7
4.
Now, through the interior of the
coach, locate and remove the engine
cover to access the top of the engine.
5.
Locate and remove the PCV tube
connected to the throttle body intake
tube. See Figure 6.
6.
Find the throttle body intake tube
and loosen it’s hose clamp.
7.
Remove the throttle body intake
tube from the engine compartment
and set aside.
INSTALL BANKS RAM-AIR
INTAKE TUBE
8.
Assemble the Banks throttle body
hose and hose clamp onto the Banks
rear intake tube. Lightly tighten the
hose clamp.
9.
Install the supplied Banks bellows
hose and hose clamp onto the other
end of the Banks rear intake tube. See
Figure 7.
10.
Locate the Banks front intake
tube and install it into the other end
of the Banks bellows hose. Make sure
the alignment of the air intake tube
is correct (Figure 8). Tighten all the
hose clamps on the Banks intake tube
assembly.
96380 v.4.0
9