Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Exhaust- Monster Sport Exhaust System '99-03 F-250_350 Pickups - Manual (Page 10)

If not installing the optional Banks
Monster Tailpipe Tip, Skip to
step 10.
9.
Insert the optional tailpipe tip
over the tailpipe outlet. Adjust the tip
past the edge of the body or where
aesthetically pleasing. Torque the band
clamp to 35 ft-lb.
10.
Remove protective wrapping from
tailpipe tip.
11.
Position all the exhaust
components such that all the hanger
pins are parallel with the frame pins
and all exhaust tubing is located
properly. Lightly tighten the clamps
to maintain position. The tailpipe tip
should be positioned 1-1 1 ⁄
2
“ below
the bottom edge of the fender. All
hangers should be hanging slightly
forward to allow for heat expansion of
the exhaust tubing (see Figure 5).
12.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
turbo and working your way back.
Torque all clamps to 35 ft-lbs.
13.
your system includes two Banks
Power logos that have been designed to
compliment the Ford badging on your
truck. We have provided measurements,
which will allow you to place these
logos in a position that gives a clean
factory look. See Figure 6.
14.
The Monster Exhaust installation
is now complete.
Figure 4- For installation of Optional Tailpipe Tip
10
96572 v.3.0