Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Tuner- Six-Gun Diesel Tuner '06-07 (iQ) Compatible with Optional Banks iQ & Speed-Loader - Manual (Page 12)

12
96817 v.3.0
4.
Find a suitable place on the
windshield for ease of access and
viewing of Banks iQ. Use location
shown in Figure 8 as a reference
for mounting Banks iQ in your
vehicle. Loosen the knob and move
the swivel suction plate to achieve
desired viewing angle of the Banks
iQ screen. Do a test fit and note the
angle necessary to achieve the correct
viewing angle.
5.
Make sure the suction cup and the
mounting area on the windshield are
clean and dry. With the suction lever
in the up position, ensure the suction
cup is flat against the windshield, and
then push the suction lever down to
secure in place.
6.
Next, remove and set the fuse
access panel aside. See Figure 9.
7.
Remove two screws located at
the bottom of the lower knee panel.
Remove the lower knee panel and set
aside. See Figures 10.
8.
Locate the Banks OBD II Interface
Cable in your kit. This cable has
three connection points. connect
the RED OBD II connector on the
Banks interface cable to the vehicle
OBD II connector. Use a cable tie as
shown in Figure 11 to secure the
Banks interface cable to the vehicle
OBD II connector. Next, connect the
6-pin connector on the Banks OBD II
interface cable to the 6-pin connector
on the Six-Gun Tuner harness.
9.
Locate the RJ12 cable (similar to
telephone connector) on your Banks
OBDII interface cable. See Figure 12.
10.
Locate Banks iQ Bridge Module and
connect the RJ12 connector into the
Bridge Module. See Figure 13.
Figure 8 Mounting location for Banks iQ, Chevy LMM Shown.