Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Tuner- Six-Gun Diesel Tuner '06-07 (iQ) Compatible with Optional Banks iQ & Speed-Loader - Manual (Page 18)

18
96817 v.3.0
6.
After confirming the locating
washer is in the #6 location, install the
switch through the 3 ⁄
8
” hole on the
backside of the instrument panel. The
alignment pin should rest in the 1 ⁄
8
”
hole and with the switch fully rotated
counter clockwise; the shaft’s flat side
should be facing the steering column.
Secure switch with internal tooth
washer and nut. Snug the washer; be
careful not to over torque the nut and
damage the plastic threads.
7.
Install the knob onto the shaft
facing the #1 Level on the Six-Gun
label. On the knob, snug the two (2)
set screws with the supplied 0.050”
hex key wrench.
8.
Route the Six-Gun Switch cable
down to the Six-Gun Diesel Tuner’s
three-connector cable underneath the
dashboard, and reinstall the IP to the
dashboard.
9.
Connect the Six-Gun Switch Cable’s
2-pin receptacle to the 2-pin plug on
the Six-Gun Diesel Tuner’s grey three
connector cable.
Warning: if excessive torque
converter slip is detected then
a Limp Home Mode override will
be set by the ECU. This LHM will
be active until torque slippage is
no longer detected or is reset by
Diagnostic Tool.
-END, SECTION 3-
Figure 17