Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Exhaust- Monster Exhaust, Split-Dual '99-03 F-250 & F-350 pickup w_o catalytic converter - Manual (Page 10)

pipe outlet.
17.
For eClb, CCsb and CClb
models, install the supplied
extension pipe on the intermediate
pipe outlet (see Figure 1).
18.
For eClb, CCsb and CClb, install
the hanger clamp on the extension
pipe outlet. Insert the hanger pin into
the corresponding vehicle rubber
hanger.
19.
unbolt and remove the stainless
steel sheetmetal attached to the
underside of the bed. leave the
heatshield portion that is attached to
the cab (see Figure 6).
20.
Install the banks Monster Muffler
onto the intermediate pipe outlet and
lightly tighten the 4” clamp / hanger
clamp. Note inlet labeling stamped on
the bottom of the muffler. Orient the
Banks Monster emboss such that it is
level with the frame.
21.
Install the y-pipe into the
Monster Muffler outlet. Insert the two
y-pipe hanger pins into the vehicles
rubber hanger (see Figure 7).
22.
Install the banks rubber hanger
onto the supplied hanger bracket.
locate the two slots on the rear
driverside frame and install the
hanger bracket assembly using the
7 ⁄ 16 ” hardware (see Figure 8).
23.
Install two 3 1 ⁄ 2 ” clamps onto the
top and bottom of the y-pipe. route
the Driver side tailpipe over the axle
and insert into the upper y-pipe.
Install the tailpipe hanger pin into the
rubber hanger.
24.
route the passenger side
tailpipe over the axle and insert into
the lower y-pipe. Install the tailpipe
hanger pin into the banks rubber
grommet.
25.
Move the spare tire to the rear
of the vehicle. adjust the tailpipe tips
to be 1 ⁄ 2 ” off the body panel and snug
the two 3 1 ⁄ 2 ” clamps. Move the spare
tire such that there is equal distance
for each tailpipe (see Figure 9). using
the provided zip ties, route the vent
hose and brake lines away the dual
tailpipes.
26.
with everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front and working your way back.
REAR MUFFLER
HANGER
HEATSHIELD
REMAINS
REMOVE
HEATSHIELD
FORWARD
Figure 6
DRIVERS SIDE
TAILPIPE
3 1/2”
CLAMP
3 1/2”
CLAMP
BANKS Y-PIPE
ORIENTATION
4“ CLAMP NOTE ORIENTATION
OF MONSTER MUFFLER
FORWARD
HANGER CLAMP
LOCATION FOR
LONG BEDS
PASSENGER SIDE
TAILPIPE
Figure 7
10
96484 v.3.0