Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Exhaust- Monster Exhaust, Split-Dual '99-03 F-250 & F-350 pickup w_o catalytic converter - Manual (Page 11)

torque the exhaust clamps evenly
to 35 ft-lbs. Make sure that each slip
is fully inserted (+/- 1 ⁄ 4 inch) and that
all mount hangers are in the forward
position (see Figure 10). torque 7 ⁄ 16 ”
hanger bracket hardware to 45 ft-
lbs. remove the protective covering
from the tailpipe tip. Caution: The
protective covering may ignite
and burn if not removed prior to
running the engine.
27.
the 2-pin warm-up valve module
needs to be installed onto the warm-
up valve connector on the vehicle wire
harness. on the pedestal under the
turbocharger, disconnect the 2-pin
connector. attach the 2-pin connector
to the banks warm-up valve module
and zip-tie the module and wire
harness away from any moving parts.
See Figure 11
28.
your system includes two
“banks power” logos designed
to complement the Ford badging
on your truck. use the provided
measurements (see Figure 12) to
position the logos for a clean factory
look.
29.
re-connect negative battery
cable(s). start the engine and
listen for exhaust leaks. tighten
the exhaust clamps as necessary.
whenever possible, tack-welding
slip connections to prevent
disengagement is recommended.
the banks split-Dual Monster exhaust
installation is now complete.
FACTORY
LEAF STOP BANKS
HANGER
BRACKET
FACTORY
FRAME
SLOT
BANKS
RUBBER
INSULATOR
BANKS
7/16”
HARDWARE
BANKS
DRIVER SIDE
TAILPIPE
FORWARD
Figure 8
BANKS
DRIVER SIDE
TAILPIPE
ZIP TIE ON
VENT HOSE
& BRAKE LINE
BANKS
PASSENGER SIDE
TAILPIPE
ADJUST SO THAT
SPARE TIRE TO
TAILPIPE CLEARANCE
IS THE SAME
MOVE SPARE
TIRE TOWARDS
REAR OF
VEHICLE
Figure 9
96484 v.3.0
11