Banks Power Jeep Trucks: (Gas ’12 - 14 3.6L) Ram-Air Intake System 3.6L Wrangler - Manual (Page 10)

10
96579 v.1.0
16.
Insert Banks intake tube into the
throttle body opening first. Then, Insert
the three Banks air filter housing mounting
pegs onto the stock grommets.
Note: Be sure that the mounting pegs
have been properly inserted onto the
grommets.
17.
Tighten the two hose clamps that
connect the Banks Ram-Air intake tube to
the throttle body.
18.
Re-Install the ccV vent hose
connection to the Banks Ram-Air intake
tube.
19.
Locate supplied hose clips and
clip on the coolant over flow hose.
Re-use the existing bolts and secure
the hose clips to the radiator. See
Figure 8.
20.
Locate and unwrap Banks logo
plate and install onto Banks intake
tube using the supplied Button head
screw. See Figure 8.
21
. Re-install the engine cover. Make
sure cover is installed correctly.
22.
You have successfully completed the
installation of the Banks Ram-Air Intake
system. Make sure to go over all hose
clamps for tightness and connectors for a
sure fit. Make sure that the intake tube is
not touching any engine components.
-EnD, SECTIon 2-
Figure 8- Installed Banks Ram-Air Intake System