Banks Power Jeep Trucks: (Gas ’12 - 14 3.6L) Ram-Air Intake System 3.6L Wrangler User Manual
Page 8
8
96579 v.1.0
7.
Remove the air filter housing
(bottom) by lifting up from the
passenger side of the engine
compartment and set aside. See
Figure 4.
8.
Install the 3 three (supplied)
Mounting Pegs onto the Banks air filter
housing so that they extend out of the
housing and then attach the E-Clips
onto the three Mounting Pegs from the
outside of the housing. See Figure 5.
9.
Locate the supplied filter hose
clamp and install onto the Banks filter.
10.
Locate the supplied rubber AIT
grommet from your Banks kit and
install onto the air intake tube. See
Figure 6.
11.
Install the AIT sensor flush into
the grommet on the air intake tube.
12.
Insert the Banks intake tube onto
the Banks Ram-Air Housing; be sure to
insert the end of the intake tube that
has an arrow on it.
13.
Insert the Banks air filter into the
end of the Banks intake tube that is
inside of the Banks Ram-Air Housing.
For proper fit be sure that the arrows
on the Banks air filter and intake tube
line up. Tighten Banks filter hose
clamp. See Figure 7.
14.
Install the hose and two hose
clamps onto the intake tube where it
will attach to the throttle body.
15.
Lower Banks intake tube and
housing into place and connect the AIT
sensor connector to the sensor before
install the intake tube.
Figure 5- Attaching mounting pegs to the housing bottom