Banks Power Jeep Trucks: (Gas ’12 - 14 3.6L) Ram-Air Intake System 3.6L Wrangler - Manual (Page 6)

6
96579 v.1.0
Use the Bill of Materials chart and
the General Assembly Drawing to
reference component nomenclature
and location. Use caution when
working in the engine compartment.
Make sure the engine has been OFF
for several hours and cool.
You are about to install the Banks
Ram-Air Intake System. Read and
follow all steps before working on the
vehicle. Some components from the
stock air intake system will remain in
service. Take caution when removing
stock air intake components from
damaging them.
1.
Remove the Engine cover from the
vehicle and set aside. The cover is held
in place by rubber grommets.
2.
Un-clip the coolant over flow hose
from the two holding clips in front
of the vehicle. Loosen the bolts and
remove the clips and bolts from the
vehicle. See Figure 2. Retain the bolts
for re-use.
3.
Loosen the band clamps at the
intake housing and throttle valve.
carefully lift the intake tube loose and
disconnect the Air Intake Temperature
(AIT) sensor connector located on the
lower part of the intake tube close to
the throttle body, by moving the red
tab back and pulling on the connector.
Remove the intake tube from the
vehicle.
4.
Remove the Air Intake Temperature
(AIT) Sensor located on the intake tube
by twisting the Senor half turn and pull
out. Set connector aside and retain
sensor for re-use.
Note: take caution when handling the
sensor.
5.
Disconnect the ccV hose from the
air intake housing. See Figure 3.
6.
Un-clip the four tabs holding the
air filter housing cover. Remove the
cover and the air filter from the engine
compartment and set aside.
Section 2
RAM-AIR INStALLAtIoN
Figure 2- Factory Stock Intake