Banks Power Chevy_GMC Trucks: Duramax LLY (Diesel ’04 - 05 6.6L) Speed Control- SpeedBrake '04-05 (PDA) For use with PowerPDA User Manual
Page 10
10
97223 v.2.0
Module by hand for 60-seconds to
create a strong bond between the
fuse box and hook & loop interlocking
fasteners.
Note: make sure the fuse box cover
is clean and free of any oil residue and
contaminates. Clean fuse box cover
with a non-oil based solvent such as
Acetone, Mineral Spirits, Denatured
Alcohol or Lacquer thinner. Read and
follow the manufactures operation
instruction for non-oil based solvent
cleanser.
If vehicle is equipped with a Banks
tuner, detach the tuner from the top
of the fuse box cover and reattach
on the fuse box side or on top of the
fuse box along with the SpeedBrake.
See Figure 5 & 6. If placing the tuner
on top of the fuse box along with
the SpeedBrake module there may
be some over hang from the tuner.
Secure the tuner so that it stays in
place. Use the supplied hook & loop
interlocking fasteners to make the
necessary adjustment to attach the
SpeedBrake to the top of the fuse box
cover and Banks tuner to the fuse box
side or top.
WaRNING: Make sure to place the
SpeedBrake Module as shown in
figure 7 to avoid a clearance issue
when closing the hood. Mount the
SpeedBrake Module as close to the
inside edge of the fuse cover as
possible.
15.
Insert the SpeedBrake 20-pin
Module connector on the wire harness
to the SpeedBrake Module. Using the
supplied cable ties, secure the wire
harness away from any heat sources
(i.e. Driver side exhaust manifold) or
moving components.
-END, SECTION 1-
Figure 7