Banks Power Chevy_GMC Trucks: Duramax LLY (Diesel ’04 - 05 6.6L) Speed Control- SpeedBrake '04-05 (PDA) For use with PowerPDA - Manual (Page 16)

16
97223 v.2.0
The SpeedBrake PowerPDA software is
supplied on a Secure Digital (SD) media
card. The software should be installed on
the Palm Tungsten E2 and run from main
memory. You can use the additional
space on the SD card to store music,
photos and other data. Refer to your
device instruction manual for using SD
cards to store data. You should leave
a copy of the SpeedBrake PowerPDA
software on the SD card as a backup for
future reference.
1.
Insert the SD card into the slot on the
top of the Palm Tungsten E2.
Note: the contents of the SD card
should appear on the screen. (the
“BanksBrake” name). See Figure 16.
2.
Press the ‘Menu’ key on the bottom
of the Palm Tungsten E2 (beneath the
‘Home’ key, see figure 13). Then select
‘Copy’. See figure 14.
3.
In the ‘Copy From’ drop down menu
select “card”. See figure 15. The ‘Copy
To’ selection will automatically change
to “Device” (figure 16). Select on the
“BanksBrake” name, if it is not already
selected or there is more than one item
in the list. Touch the “Copy” button.
A dialog box will appear, indicating
the Palm Tungsten E2 is copying the
software from the SD card (figure
17). Once completed, press the “Done”
button.
4.
Select the drop-down menu in the
upper right hand corner of the screen.
Touch the button labeled ‘All’. The Banks
SpeedBrake PowerPDA software is now
installed. You may now remove the SD
card from its slot.
5.
To start the SpeedBrake PowerPDA
software, touch the icon called
“BanksBrake”. See figure 18.
-END, SECTION 3-
Figure 14 Figure 15