Fuse access panel – Banks Power Chevy_GMC Trucks: Duramax LLY (Diesel ’04 - 05 6.6L) Speed Control- SpeedBrake '04-05 (PDA) For use with PowerPDA User Manual
Page 12
12
97223 v.2.0
5.
Find the Banks OBD II Interface
Cable in your kit. Connect the Banks
Interface Cable to the vehicle’s OBD II
connector. Use a cable tie, as shown
in figure 11, to secure the Banks
Interface Cable to the vehicle’s OBD II
connector.
6.
Next, connect the 6-terminal
connector on the Banks OBD II
Interface Cable to the 6-pin connector
on the Banks SpeedBrake wire
harness.
Note: If your vehicle is equipped with a
Banks Diesel tuner, optional tuner-to-
SpeedBrake cable will be needed (P/N
55411). See Figure 12. Disconnect the
6-pin terminal connections between
Banks oBD II Interface Cable and Banks
Diesel tuner. Connect the oBD II 6-pin
male connector to the optional tuner-
to-SpeedBrake 6-pin female connector.
Connect the two (2) wire 6-pin male
Figure 9
Figure 10
Fuse Access
Panel