Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Intake- Ram-Air intake system '97-06 Jeep 4.0L User Manual
Page 11
Notification
The Banks Ram-Air Filter comes
pre-oiled and no oiling is
necessary for initial installation.
Use Banks Ram-Air Filter cleaning
system (part # 90094), available
from Gale Banks Engineering to
service the Air Filter. Follow the
instructions included with the
cleaning system to clean and
re-oil your Banks Ram-Air Filter.
1.
PRe-CLeANING
Tap the element to dislodge any large
embedded dirt, then gently brush with
a soft bristle brush. NOTE: If complete
cleaning is not practical at this time,
reoil the element and reinstall in your
vehicle.
2.
SPRAy-oN CLeANING
Spray Banks air-filter cleaner liberally
onto the entire element
and let
soak for 10 minutes.
PAN CLeANING
Large air-filter
elements can be
rolled or soaked in a
shallow pan of
Banks air-filter
cleaner. Remove
immediately and
let soak for
approximately 10 minutes.
3.
CLeANING hINTS
Use only Banks air-filter cleaner. No
gasoline cleaning, No steam cleaning,
No caustic cleaning solutions, No
strong detergents, No high-pressure
car wash, No parts cleaning solvents.
Any of these No’s can cause harm to
the cotton filter media plus SHRINK
and HARDEN the rubber end caps.
4.
RINSe oFF
Rinse off the element with low-
pressure water. Tap water is okay.
Always flush from the clean side to
dirty side. This removes the dirt
and does not drive it into the filter.
5.
DRyING hINTS
Always dry naturally. After rinsing,
shake off all excess water and let the
element dry naturally. DO NOT USE
cOMPRESSED AIR – DO NOT USE OPEN
FLAME – DO NOT USE HEAT DRYERS!
EXcESS HEAT WILL SHRINK THE
cOTTON FILTER MEDIA. cOMPRESSED
AIR WILL BLOW HOLES IN THE
ELEMENT.
Section 3
RAm-AIR FILTeR CLeANING INSTRuCTIoNS
96575 v.3.0
11