Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Intake- Ram-Air intake system '97-06 Jeep 4.0L - Manual (Page 9)

14.
Locate the supplied rubber AIT
grommet and install in the air intake
tube. Install the AIT sensor flush into
the grommet on the air intake tube.
See Figure 6.
Note: Use the supplied grommet plug
if your vehicle does not utilize an AIT
sensor.
15.
Locate the supplied PCV hose and
spring band clamps. Fit spring band
clamps over PCV hose on both ends.
Install one end on the Banks short
intake tube and the other end to the
PCV fitting on top of the valve cover.
16.
Re-connect battery grounds.
You have successfully completed
the installation of the Banks Ram-Air
Intake system. See Figure 7. Make
sure to go over all hose clamps for
tightness and connectors for a sure fit.
Make sure that the intake tube is not
touching any engine components.
-END, SECTION 2-
Figure 6
96575 v.3.0
9