Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Intake- Ram-Air intake system '97-06 Jeep 4.0L - Manual (Page 6)

Use the Bill of Materials Chart and
the General Assembly Drawing to
reference component nomenclature
and location. Use caution when
working in the engine compartment.
Make sure the engine has been OFF
for several hours and cool.
You are about to install the Banks
Ram-Air Intake System. Read and
follow all steps before working on the
vehicle. Some components from the
stock air intake system will remain
in service. Take care when removing
stock air intake components to not
damage them.
1.
Disconnect the Air Intake
Temperature (AIT) Sensor located on
the backside of the intake tube and
set aside. See Figure 2.
Note: Some models do not come
equipped with an AIT sensor. Continue
to step 2.
2.
Disconnect the PCV hose from the
fitting on top of the valve cover and
leave attached to the air intake tube.
3.
Loosen both air intake hose clamps
and remove the air intake tube from
the engine compartment.
4.
Unclip the air housing cover latches
and remove the cover and air filter
from the engine compartment and set
aside.
5.
Remove the three screws
accessible from the opening of the
air housing and under the right wheel
housing and set aside. Keep removed
screws, washers and rubber bushing.
Some components will be reused in a
later step. See Figure 3.
6.
Remove the air housing from the
engine compartment and set aside.
Section 2
RAm-AIR INSTALLATIoN
Figure 2
6
96575 v.3.0