Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Intake- Ram-Air intake system '97-06 Jeep 4.0L User Manual
Page 7
7.
Install the Banks Air Housing into
the engine compartment and align the
screw holes to the fender panel.
Depending on the model year of
vehicle, not all screw holes will be
utilized. Note: Some models utilize two
screw holes. See Figure 4.
8.
Locate the previously removed
stock air housing fastening hardware.
Discard the washer, rubber grommet
and metal sleeve. Keep only the nut
and bolt. Install the Banks Air Housing
into position and fasten using stock
nut and bolt. See Figure 1.
9.
Install the Banks Air Filter into the
housing. Make sure to install the filter
emblem end flush into the recessed
area of the Banks Air Housing. Note:
the filter may fit snug into the housing.
Take care not to damage the filter
when fitting into air housing. See
Figure 5.
10.
Locate supplied hose clamp and
fit loose on Banks air filter.
11.
Locate the supplied short intake
tube. Install the short intake tube onto
the Banks air filter. Lightly tighten the
hose clamp.
12.
Locate the supplied long intake
tube, 4” Dia. hump hose and hose
clamps. Fit hose clamps over hump
hose on both ends and slip onto long
intake tube. Then fit the hump hose
end of the long intake tube into the
short intake tube attached to the
Banks air filter. Lightly tighten the hose
clamps.
13.
Locate the remaining hose and
hose clamps. Fit hose clamps over
hose on both ends and slip onto
remaining intake opening. Slip the
hose over the throttle body till flush
with bottom. Lightly tighten the hose
clamps.
Figure 3
96575 v.3.0
7