Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Pack & Stinger Systems w_EconoMind '03-05 Compatible with Banks iQ User Manual
Page 21
96820 v.4.0
21
1.
Place the EconoMind Diesel
Tuner box on top of the fuse box
located in the left front side in the
engine compartment. See Figure
19. The in-cab cable with the three
small connectors will be routed into
the cabin via the grommet on the
firewall. The other two harnesses
will be routed under the intake to
their respective locations listed in the
following steps.
2.
Locate the rubber grommet on the
drivers side firewall. Using a utility
knife, make a 1.5-inch-long slit in the
grommet next to the wire harness.
Be careful not to cut or damage
the harness. See Figure 20 for the
proper location of the required cut.
Insert a screwdriver from the engine
compartment into the cut hole and
gently thrust it through the grommet.
3.
Inside the vehicle, remove the
lower dash panel beneath the
steering column by removing the two
(2) screws at the bottom of the panel.
Retain the screws for re-installation.
NOTE: There are also two (2) clips
located at the top corners of the
panel, which hold the panel in place.
These clips can be released by gently
pulling on the corners of the panel.
Use caution to avoid damaging the
panel during removal.
4.
Remove the electrical connector
bracket on the left hand side of the
support below the steering column in
front of the firewall by removing the
two (2) bolts. This will allow access
to the inner grommet. See Figure 21.
5.
Cut the grommet on the firewall
inside the vehicle along the hole
created by the screwdriver in Step 2.
6.
Locate the in-cab cable with the
three connectors. From the engine
compartment, push the in-cab cable
through the hole cut in the firewall
grommet. NOTE: Taping the end of
the cable to a piece of stiff wire (i.e.
coat hanger) may make routing the
cable through the firewall a simpler
task. The stiff wire should be pushed
through the slit in the grommet and
then the wires can be attached to
the stiff wire and pulled through the
hole in the grommet.
CAuTIoN: Pull gently to avoid
damage to the cable connectors.
Always pull on the cable sheath
rather than the wires themselves.
Section 5
BANKS ECoNoMIND DIESEL TuNER INSTALLATIoN
Figure 20
Figure 19
Figure 21