Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Pack & Stinger Systems w_EconoMind '03-05 Compatible with Banks iQ User Manual
Page 25
96820 v.4.0
25
Section 6
MouNTING AND CoNNECTING THE BANKS iQ
If not installing the optional Banks
iQ, skip to Section 7.
WARNING: Below 32
o
F (0
o
C) or
above 140
o
F (60
o
C), the Banks iQ
may be susceptible to damage
as a result of extended exposure
to sunlight, heat or extreme
cold. It is highly recommended
that the Banks iQ be removed
from its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period
of time. Gale Banks Engineering
is not responsible for damage to
Banks iQ resulting from exposure
conditions.
CAuTIoN: Do not use force
when working on plastic parts.
Permanent damage to the part
might result.
1.
Locate the Window Mount
Assembly in your kit.
2.
Assemble the Banks iQ docking
station to the Universal mount by
inserting and sliding the Universal
mount tab into the docking station
groove. Hand tighten the nut behind
the docking station to hold the
docking station in place.
3.
Attach the window mount to your
Banks iQ. See Figure 31. Align and
place the two (2) lower tabs on the
window mount to the corresponding
slots on the bottom of Banks iQ first
then snap the top of Banks iQ into
place.
NOTE: There may be a snug fit when
installing the Banks iQ into the window
mount. Take care not to force this
process.
4.
Find a suitable place on the
windshield for ease of access and
viewing of Banks iQ. Use location
shown in Figure 32 as a reference
for mounting Banks iQ in your
vehicle. Loosen the knob and move
the swivel suction plate to achieve
desired viewing angle of the Banks
iQ screen. Do a test fit and note
the angle necessary to achieve the
correct viewing angle.
5.
Make sure the suction cup and
the mounting area on the windshield
are clean and dry. With the suction
lever in the up position, ensure
the suction cup is flat against the
windshield, and then push the
suction lever down to secure in
place.
6.
Next, remove and set the side
dash access panel aside.
7.
Locate the RJ12 cable (similar
to telephone connector) previously
secured behind the knee panel.
Remove the knee panel to gain
access to the RJ12 cable. See Figure
33.
8.
Locate Banks iQ Bridge Module and
connect the RJ12 connector into the
Bridge Module. See Figure 34.
Figure 31 Attaching Banks iQ to window mount
Figure 32 Mounting location for Banks iQ