Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Speed Control- Banks Exhaust Brake '01-04 User Manual
Page 6
6
96994 v.5.0
19.
Attach the pneumatic hose to
the air compressor panel by inserting
the hose into the push-lock fitting as
shown in
Figure 5.
20.
Mount the compressor panel
assembly in the vehicle using the five
(5) previously removed bolts. Re-
install the air filter box. Re-connect
the Mass Airflow Sensor.
21.
Locate the GREEN and BLACK
wire pair on the Banks Brake Harness
(previously pulled through the
firewall). Route the wires across the
engine by following the factory wire
harness towards the right front of
the engine compartment. Plug the
BLACK wire into the BLACK wire on
the air compressor panel. Plug the
GREEN wire into the GREEN wire on
the air compressor panel.
22
. Route the compressor power
wire (fuse holder with a ring
terminal) to the battery junction
block as shown in
Figure 6. Remove
the nut from the bus bar stud and
place the ring terminal over the
stud. Re-install the nut on the
bus bar stud.
23.
Remove instrument panel by
gently pulling around edge of panel.
NOTE: To facilitate removing the
panel, the auto-matic gearshift lever
should be placed in low gear and the
tilt steering wheel should be lowered
as much as possible.
24.
Route the wire harness to the
locations shown in
Figure 7.
25.
Attach the two (2) ground wires
(BLACK wire with ring terminals) to
the existing studs (see
Figure 7)
by removing the existing nut and
placing the ring terminal over the
studs. Re-install the hold down nuts.
26
. Attach power switch wires (RED,
YELLOW, BLACK) to power switch
as shown in
Figure 8.
27.
Install the supplied red T-tap
onto the DARK BLUE wire at the
throttle pedal switch assembly (See
Figure 9). Install the BLUE Banks
Brake wire onto the T-tap connector.
28.
Locate the junction block. The
junction block is located on the
firewall behind the emergency brake
pedal, under the instrument panel.
29.
Remove the black plastic cover
from the junction block by removing
the center retaining nut.
30.
Remove the junction block from
its mount by depressing the lock tabs
on the sides of the junction block and
pulling the junction from its mount.
31.
Turn the junction block over to gain
access to the wiring on the backside.
32.
On 2001-2002 models: Locate one
of the GREEN wires with the WHITE
stripe (see
Figure 10A). Pins D5, E5,
F5 and F6 are all acceptable
locations for the GREEN wire with
WHITE stripe.
On 2003 models: Locate the GREEN
wire with WHITE stripe in Pin E6
(see
Figure 10B).
Figure 5
Figure 6