Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Speed Control- Banks Exhaust Brake '01-04 User Manual
Page 9
96994 v.5.0
9
43.
Route the 14-pin Banks Brake
connector as shown in
Figure 7.
Plug the 14-pin connector into the
supplied Computerized Brake
Controller (CBC).
44.
Ensure that the surface of the
sheet metal structure is clean and
free of oil, grease, and dirt. Clean and
dry as required using a cloth
dampened with rubbing alcohol or
similar cleaning solution.
CAUTION:
Do not spray fluid directly onto
any electrical equipment, or
damage to the equipment may
result. Peel the protective backing
off of the adhesive tape on the
backside of the CBC. Install the CBC
onto the sheet metal structure under
the dash as shown in
Figure 13.
Hold the module against the vehicle
structure for approximately 1 minute
while applying pressure to allow the
tape to properly adhere to the
surface.
45.
Locate the “switch template” at
the back of this manual (
page 19).
Cut the template out of the manual
using scissors. Be sure to follow
the outline of the template as
closely as possible. Attach the
template to the backside of the
instrument panel (previously
removed) using tape
(see
Figure 14).
46.
Using a
1
⁄
8
" drill bit, drill a pilot
hole through the center of the cross
hairs on the template. Flip the panel
over and drill a
1
⁄
2
" hole at the
location of the pilot hole (the use of a
“Unibit” drill bit is recommended to
help eliminate burrs and to produce a
round hole). Remove the template
from the backside of the dash panel.
NOTE: It is very important that hole is
located per the provided template.
The switch may not clear the dash
structure if the hole is shifted to
another location.
47.
Remove the chrome bezel nut
from the power switch shaft.
Figure 11 (2001-02) Fuse Block
Figure 11 (2003) Fuse Block
Figure 13
Figure 12