Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Speed Control- Banks Exhaust Brake '01-04 User Manual
Page 8
33.
Install the supplied red T-tap on
one of the wires located in the
previous step. Plug the ORANGE
Banks Brake wire into the T-tap
connector.
34.
Reinstall the junction block in its
mount. Reinstall the junction block
cover and secure with retaining nut.
35
. Locate the brake light switch on
the top of the brake pedal assembly
(see
Figure 7). Locate the PURPLE
wire that goes into the brake pedal
switch connector. Cut the PURPLE
wire approximately 4" from the
brake pedal switch connector.
36.
Using an appropriate wire
stripping tool, strip approximately
1
⁄
4
"
of insulation from each end of the
previously cut PURPLE wire.
37.
Using the appropriate
crimping tool, crimp one of the
supplied pink ultra fast tab (male)
Fast-on Connectors to one of the
PURPLE wires.
38.
Using the appropriate crimping
tool, crimp one of the supplied pink
ultra fast receptacle (female) Fast-on
Connectors to the remaining PURPLE
wire.
39.
Connect the BROWN Banks
Brake wires to the fast-on connectors
that have been previously installed
on the PURPLE wires.
40.
Locate the fuse box cover on the
driver's side of the dashboard.
Remove the cover exposing the fuse
block. Locate the 10 AMP "SEQ ACC"
fuse as shown in
Figure 11. Remove
the fuse and install the supplied fuse
tap on the fuse body. Re-install the
fuse in the fuse block. See
Figure 12
41.
Route the BLACK (with fuse
holder) wire to the fuse block and
connect the end of the BLACK wire
to the previously installed fuse tap.
42.
Re-install fuse cover.
Figure 10A Junction Block
Figure 9
Figure 10B Junction Block
8
96994 v.5.0