Banks Power Chevy_GMC Trucks: Gas ’99 - 14 4.3,4.8,5.3,6.0,6.2,8.1 Exhaust- Monster Exhaust, Single Passenger side exit '11 (6.0L 2500HD) Chevy-GMC 2500HD 6.0L CCSB User Manual
Page 5
96531 v.1.0
5
Intermediate pipe onto the previously
cut pipe outlet. Be sure the
intermediate pipe jog is orientated
with the jog going up towards the cab.
Lightly tighten the 3-
1
/
2
” clamp on the
intermediate pipe inlet. (see Figure 3).
NOTE: All clamps should be positioned
at the beginning of the slots (on the
1
/
2
circle punch).
NOTE: Once the pipe / muffler has
been completely engaged in the slip
joint, mark the pipe with a scribe or
tape for reference when tightening the
clamps later in the installation. Mark
each slip joint in this fashion.
6.
Install the front muffler hanger
clamp onto the Intermediate pipe
outlet.
7.
Install the Monster Muffler inlet
(Note the inlet labeling of the muffler)
onto the intermediate pipe outlet.
Orient the Monster logo such that it
is visible from the passenger side and
parallel with the frame rail. Align the
hanger clamp onto the muffler inlet
(see Figure 3).
8.
Install the rear muffler dual hanger
clamp onto the Monster Muffler outlet.
Insert the hanger pins into the vehicles
rubber hangers (see Figure 4).
9.
From the vehicle rear, route the
tailpipe over the rear end. Install the
tailpipe into the Banks Muffler outlet.
Start the tailpipe hanger pin into the
corresponding vehicle rubber hanger.
Lightly tighten the rear muffler hanger
clamp to secure the tailpipe.
10.
Adjust the tip about
1
/
2
” under the
body panel, such that the tip position
is aesthetically pleasing.
11.
Adjust each of the pipes to ensure
that all of the hanger pins are parallel
with the frame mounted pins and that
the rubber hangers are all positioned
slightly forward (See Figure 5). This
allows the hangers to be properly
positioned once the exhaust reaches
operating temperature.
Figure 3