Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Power Systems- Stinger, Stinger-Plus & PowerPack systems '19991_2-2003 F250_F350 Trucks & Excursion (non-cat) - Manual (Page 18)

may not start if the coating on the
ECU connector is not completely
removed or if there is a mismatch of
codes. A quick indication of module
connections that are not cleaned
properly is that the “Wait to Start”
indicator will fail to light and the
“Check Engine” warning indicator will
stay lit after the key is switched on. If
the engine fails to start, re-clean the
ECU connector, reinstall the module
and try again. If the problem persists,
contact technical service at Gale
Banks Engineering to confirm that the
ECU and OttoMind codes match.
87.
Start the engine and allow
it to warm up. Drive the vehicle,
listening for any exhaust leaks or
rattles. Adjust and tighten clamps
or reposition the piping if required.
When positioning of piping is
finalized, it is a good practice to
place tack welds at any slip joints
in the exhaust system to prevent
slippage.
–END, SECTION 7–
Figure 10
18
96334 v.5.0