Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Speed Control- SpeedBrake '07-08 (PDA) For use with PowerPDA - Manual (Page 14)

14
97229 v.8.0
Section 2
MoUNTING THE DoCkING STaTIoN aND
CoNNECTING THE BaNkS PoWERPDa
Figure 11
NoTE: This system has been
designed for use with the Palm
Tungsten E2 PDA.
WaRNING: The PDa may be
susceptible to damage as a
result of extended exposure
to sunlight, heat or extreme
cold. It is highly recommended
that the PDa be removed from
its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period
of time. Gale Banks Engineering
is not responsible for damage to
PDas resulting from exposure
conditions.
CaUTIoN: Do not use force
when working on plastic parts.
Permanent damage to the part
might result.
1.
Locate the universal mount and
docking station in your kit. Interlock
the docking station to the universal
mount by inserting and sliding the
universal mount tabs into the docking
station grooves. See figure 11.
2.
Find a smooth, flat surface suitable
for ease of access and viewing of
the PowerPDA. See figure 6 for an
example. Loosen both knobs and move
the swivel suction plate and docking
station to achieve desired viewing
angle of the PowerPDA screen. Do a
test fit and note the angle necessary
to achieve the correct viewing angle.
3.
Tighten both knobs to lock in the
position (figure 11).
Note: If the universal mount swivel
does not move or is tight after
loosening the hold down knob, then
remove the previously inserted
docking station and slightly loosen the
tension screw. See Figure 12.