Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Speed Control- SpeedBrake '07-08 (PDA) For use with PowerPDA User Manual
Page 16
16
97229 v.8.0
Figure 14 optional tuner-to-SpeedBrake wire
WaRNING: The charging cable on
the docking station is designed
to supply a constant low-voltage
power source (+5vdc) to the
Banks PowerPDa and is “live”
as long as the system’s oBD II
Interface Cable is completely
installed and the RJ12 connector
is plugged into the docking
station. although this charging
cable is short and its circuitry
is fuse protected, the user is
expected to take appropriate
measures to prevent small
children and/or pets from contact
with any part of this system.
10.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash.
11.
Double check everything to make
sure it is securely fastened and it is
not near any heat source or moving
parts before starting engine.
12.
Set up the Banks PowerPDA
according to its instructions.
13.
Re-connect the negative (ground)
cable(s).
-END, SEcTION 2-
Figure 13