Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Powertrain- Banks Billet Torque Converter '01-08 Chevy_GMC Trucks: Duramax Allison Trans - Manual (Page 12)

CAUTION: Verify that the trans-
mission is secured to the lifting
device. When torque converter is
removed, the transmission’s cen-
ter of gravity will shift and trans-
mission may become unstable.
25.
Carefully slide the torque convert-
er out of the transmission.
WARNING: Install 2 torque con-
verter lifting handles or bolts into
2 lugs on the front of the torque
converter to prevent severe injury
and to ease remove of torque con-
verter. See Figure 9.
Note: Inspect the oil seal on the front
pump of the transmission. If there are
signs of leakage or damage, the seal
should be replaced prior to installing
the new torque converter.
26.
Drain the transmission fluid and
replace transmission oil filter and trans-
mission pan gasket.
Banks Torque Converter
Installation
.
27.
Lubricate the splines shaft seals
inside the torque converter housing
with factory recommend transmission
assembly lubricant to prevent damage
when installing Banks Torque Con-
verter.
28.
Lubricate the Banks converter
drive pilot hub, oil pump and the con-
verter pilot hub by pouring one quart of
GM Goodwrench DEXRON ® VI ATF fluid
into the pilot hub.
CAUTION: When installing Banks
Torque Converter, be careful not
to damage the pump gear O-ring
or Hub-Seal.
Figure 9
12
96732 v.2.0