Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Powertrain- Banks Billet Torque Converter '01-08 Chevy_GMC Trucks: Duramax Allison Trans User Manual
Page 14
C. Install the Torsion Bar Removal
Tool to the Adjustment Arm and the
Cross Member. Make sure the Re-
moval Tool sits on the notch on top
of the Cross Member. See Figure 2.
D. Add tension on the Adjustment
Arm until the Adjustment bolt and
Adjuster nut can be installed.
E. Install the Adjustment bolt and
Adjuster nut and adjust the bolt and
nut to realign to the marks made
during removal process.
Note: Refer to factory recommen-
dation on Torsion Bar adjustment.
F. Remove the Removal Tool.
46.
Reinstall exhaust hanger and
reconnect the exhaust hanger pin into
the rubber grommet.
47.
Reconnect exhaust components
and clamps
48.
Reconnect the fuel line retainer
bolts on the driver side of transmission.
49.
Verify that all previously removed
components are reconnected, all tools
used are accounted for and all bolts
are tightened to manufacture specifica-
tions.
50.
Fill the transmission with the fac-
tory recommended GM Goodwrench
DEXRON
®
VI ATF.
CAUTION: DO NOT overfill trans-
mission fluid. Fill transmission
with 6 quarts then start your
vehicle and check fluid level. Add
ATF fluid as needed.
51.
Reconnect the battery cable(s).
52.
Start the vehicle and allow
engine to reach normal operating
temperatures. With the vehicle lightly
loaded, accelerate gently and allow the
torque converter to lock and unlock a
minimum of fifteen (15) times. Monitor
transmission temperatures and stall
speed to verify the torque converter is
operating normally. Check transmission
fluid level and add ATF fluid if needed.
Installation of the Banks Torque Con-
verter is now complete.
14
96732 v.2.0