Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Powertrain- Banks Billet Torque Converter '01-08 Chevy_GMC Trucks: Duramax Allison Trans - Manual (Page 7)

96732 v.2.0
7
the converter hub and hub drive
notches off before installing the
torque converter into the trans-
mission or damage may result.
5.
Remove the factory front catalytic
converter hanger pin from the Exhaust
hanger rubber grommet. See Figure 2.
Note: Loosen the exhaust clamps and
disconnect the exhaust components
to ease the removal of the hanger pin
from the rubber grommet and to make
room for starter and transmission
removal.
Note: Spray lubricant may assist in
hanger pin removal.
6.
Remove the Exhaust hanger from
the right side of the transmission.
7.
Torsion Bar Removal
A. Install the Torsion Bar Removal
Tool to the Adjustment Arm and the
Cross Member. See Figure 3.
Note: There is a notch on top of the
Cross Member to properly sit the
Removal Tool.
Figure 3