Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Speed Control- Banks SmartLock (used with non-CBC-equipped Banks Brake) - Manual (Page 4)

Dear Customer,
Your new Banks
SmartLock is
an integrated
electronic control
that seamlessly
locks the torque
converter, raises
transmission line-
pressure, reduces
transmission
temperatures and
optimizes braking
performance.
If you have
any questions
concerning the
installation of the
Banks Smartlock
Trans Brake, please
call our Technical
Service Hotline
at (888) 839-2700
between 7:00 am
and 5:00 pm (PT).
If you have any
questions relating
to shipping or
billing, please
contact our
Customer Service
Department at
(888) 839-5600.
Thank you.
1.
For ease of installation of
your Smartlock Trans Brake,
please read this 8-page
Owner’s Manual before
starting any work. Become
thoroughly familiar with all
components and phases of the
installation before beginning
any work.
2.
Inspect all components
supplied for any foreign
material that may have
entered during shipping and
handling.
3.
The installation should
be performed at a time
when the vehicle has been
allowed to completely cool.
This installation requires the
installer to work near surfaces
that may remain hot after the
vehicle has been run. Failure
to allow the vehicle to cool
may result in personal injury.
4.
Pay particular attention
to the routing of wires and
hoses. Keep them away from
exhaust heat, moving parts
and sharp edges that may
cause cuts or other damage.
Route or tie away from critical
areas as required. Keep all
wires a minimum of 6” from
hot exhaust parts, 8” or more
is recommended whenever
possible.
warning! Never work
under any vehicle
supported only by a jack
of any kind. Do NoT uSE
concrete blocks or other
masonry items that may
collapse under the vehicle
weight.
• Smartlock Trans Brake
• Pneumatic line pressure
boost actuator assembly
• Wiring harness
• Bypass connector
• Owner’s manual
• Warranty Statement
• Cable Ties (13)
• T-Tap (2)
• 1 ⁄
4
” male spade connector
(1)
• 1 ⁄
4
” female spade receptacle
(1)
• 1 ⁄
4
”-20 bolt (1)
• 1 ⁄
4
”-20 nylock nut (1)
• 1 ⁄
4
” washers (2)
General Installation Practices
Note: This system is for use on vehicles which have been
equipped with a Banks Brake which utilizes a mechanical
throttle switch. This system is NoT compatible with the
Banks Computerized Brake Controller (CBC).
System
Includes:
4 |
9 7 0 5 2 v . 3 . 0