Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Speed Control- Banks SmartLock (used with non-CBC-equipped Banks Brake) - Manual (Page 8)

5.
Locate the end of the
wire harness with the white
10-pin connector. Plug this
connector into the Smartlock
Trans Brake.
6.
Drill a 1 ⁄
4
” hole through
the sheet metal frame at the
location shown for attaching
the wiring harness ground
lead. Secure the lead with
the
1 ⁄
4
-20 bolt, nylock nut and
washers provided. See Figure
10.
7.
Route remaining length
of wire harness through the
firewall grommet identified
in Step 2. Once inside the
engine compartment, route
the harness leads along the
underside of the cowl towards
the black air filter housing
assembly. Secure the harness
with the cable ties provided.
8.
Remove the black air filter
box assembly and air inlet
hose to gain access to the
three PCM connectors located
on the lower passenger side
firewall.
9.
Install a red T-Tap
connector on the 18 AWG
white wire with an orange
tracer at pin 27 of connector
2 (middle connector of three).
For 1994-95 vehicles the
circuit is located at pin 47 of
PcM connector. See Figure
11. Connect the violet wire
from the Smartlock harness to
the T-Tap.
NOTE: Be sure that the tab
on the violet wire is properly
seated in the slot of the T-Tap
connector or the Smartlock
will fail to function properly.
10.
Install a red T-Tap
connector on the 18 AWG
orange wire with a white
tracer at pin 13 of connector
3 (left of three). Connect the
pink wire from the SmartLock
harness to the T-Tap.
For 1996-98 vehicles, the
circuit is located at pin 6 of
connector 3 and is a light
green wire with an orange
tracer. For 1994-95 vehicles,
the circuit is located at pin
37 of PcM connector and is a
light green wire with orange
tracer.
11.
Locate the 18 AWG
orange wire with a black
tracer at pin 11 of connector
2 (middle connector of
three). For 1994-95 vehicles
the circuit is located at pin
54 of PcM connector. cut
and strip the wires and
Figure 10
Ground
wire
Figure 11
8 |
9 7 0 5 2 v . 3 . 0