Banks Power Ford Trucks: (Gas ’87 - 97 7.5L EFI) PowerPack, Stinger & TorqueTube system '87-97 For Use w_ 460 EFI Engine - Manual (Page 10)

10 P.N. 96352
Figure 5a
16.
Reinstall oxygen sensor in Y-pipe and plug
oxygen sensor lead into vehicle wire loom. Make
sure oxygen sensor wiring is routed to prevent it from
contacting hot exhaust piping. Use a small dab of anti-
seize on the sensor threads only. on 1996 and later
California models, reinstall all three sensors, making
sure that each one is installed in it’s original location
with the proper wire connected to it.
17.
Install the catalytic converter on the Y-pipe
assembly. On models with a 3” slip connection
at the converter inlet, install 3” U-clamp, but leave
clamp loose enough for adjustment. On models with a
4-bolt converter inlet flange, install new inlet gasket,
provided, then mount converter using original lock nuts.
Reconnect air injection piping to catalytic converter
using original hardware. See Figure 4 .
18.
Place the CARB E.O. decal under the hood in a
place that will be visible to service personnel.
For torquetube only installation, proceed to step 25.
19.
If the vehicle is a Standard Cab (not Super Cab or
Crew Cab) model, install a catalytic-converter
outlet adapter on the catalytic converter. Install a 3 x 3”
adapter on converters with a 2 1 ⁄
2
” outlet. See Figure 5 .