Banks Power Ford Trucks: (Gas ’87 - 97 7.5L EFI) PowerPack, Stinger & TorqueTube system '87-97 For Use w_ 460 EFI Engine - Manual (Page 8)

FIGURE 4
flange, and should be adjusted by bending as necessary
so heatshield does no press against plug boot. Contact
of plug wire boot by heat shield could cause a shorted
plug if insulation is marginal. In some cases it may be
advisable to trim material from the heat shield with
snips to provide adequate clearance between the shield
and plug wire boot.
14.
on ‘93 and later models, install the starter
heatshield by first slipping the No. 56 hose
clamp through the slots in the heatshield as shown in
Figure 3. Now with the heatshield between the
TorqueTube exhaust manifold and the starter, feed the
tail of the No. 56 hose clamp between the solenoid and
starter motor, and tighten.
NOTE: Banks PowerPack system #48859 fits Super Duty
applications that do not utilize a catalytic converter.
For steps 15 through 17, disregard references to a
catalytic converter and refer to illustration 5a rather
than 5.
15.
Install new Y-pipe between TorqueTube
manifold outlets and catalytic converter. Install
exhaust donut seal gaskets between Y-pipe and
TorqueTube manifold outlets as shown in Figure 4,
install bolts to join floating flanges but leave bolts just
tight enough to allow for Y-pipe position adjustment.
8 P.N. 96352