Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Intake- Banks Ram-Air Intake system '03-07 235, 250, 305 and 325 HP, Dodge Cummins 5.9L (24-valve) Trucks User Manual
Page 15
to provide clearance. Be careful not
to break the condenser lines when
adjusting clearance. See Figure 11.
17.
Fasten the Banks air filter housing
to the well-nuts by tightening the
supplied
3
⁄
8
bolt and washer until snug.
Tighten the air housing bracket nut to
the radiator core support. Tighten the
bracket to the air housing using an
open-end wrench. See Figure 12.
18.
connect the Banks hose to the
Banks inlet tube and tighten hose
clamp.
Note: Ensure Banks hose is up to and
touching the raised bead on the Banks
intake tube.
19.
Install second hose clamp and
leave loose.
20.
Install Banks intake hose and
intake tube to the compressor inlet.
Note: Ensure hose is flush against step
on compressor inlet. Hand tighten the
hose clamp. See Figure 13.
21.
Place Banks air filter cover onto
the Banks air filter housing.
22.
Align intake tube with cover, and
then tighten the hose clamp on turbo
compressor inlet. See Figure 14.
23.
Remove factory filter minder from
factory air housing. Remove rubber
grommet from factory air housing.
24.
Install factory filter minder rubber
grommet into the Banks cover. Insert
the factory filter minder into rubber
grommet.
25.
Remove cover from housing.
Install Banks bellows with hose clamps
to Banks Intake tube.
26.
Loosely install the hose clamp to
the Banks air filter.
Figure 14
96489 v.5.0
15