Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Intake- Banks Ram-Air Intake system '03-07 235, 250, 305 and 325 HP, Dodge Cummins 5.9L (24-valve) Trucks - Manual (Page 18)

18
96489 v.5.0
30.
Remove the stock IAT sensor
from the factory air housing.
31.
Install IAT sensor into Banks
Intake tube using supplied 6 ⁄
32
screws.
See Figure 17.
Note: ensure o-ring is in good
condition.
32.
connect the IAT connector to the
IAT sensor.
Note: Route harness away from the
exhaust manifold heat shield.
33.
Re-connect battery grounds.
You have successfully completed
the installation of the Banks Ram-Air
Intake system. See Figure 18. Make
sure to go over all hose clamps for
tightness and connectors for a sure fit.
Make sure that the intake tube is not
touching any engine components.
-END, SECTION 2-