Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Powertrain- Banks Billet Torque Converter '99-03 Trucks equipped with E4OD or 4R100 Transmissions - Manual (Page 7)

Tools Required:
•
3 ⁄
8
” and 1 ⁄
2
” drive ratchets with
metric sockets including 1 ⁄
2
” and
3 ⁄
8
” drive extension
• Metric box-end wrenches
• Standard and Phillips head
screwdrivers
• T45 Torx bit
• Standard and needle-nose pliers
• Clean shop towels or rags
• Transmission hoist
• Floor jack
• Drain pan
• 320-400 grit sandpaper
• Measuring ruler
• Pry bar or channel lock pliers
• Grease pen
• Foot-pound torque wrenches
• Multipurpose Grease
Highly recommended tools and
supplies:
• Flywheel rotating tool
• Penetrating oil or light lubricant
spray
• For 4x4 models: Second
transmission hoist
• Transmission hoist adapter
• Torque converter holding tool
• Transmission fluid filter
• Transmission pan gasket
Notice To Installer:
1.
In order for the Banks Torque
Converter to function as designed, the
transmission must be re-calibrated to
increase transmission line pressure
and adjust shift timing. Banks highly
recommends installing the Banks
Transcommand in conjunction with
the Banks Torque converter. Failure
to re-calibrate the transmission may
lead to excess lock-up clutch wear
and poor shift performance. Banks
Transcommand (E4OD, P.N. 62560;
4R100, P.N. 62570) is available from
Gale Banks Engineering or through
authorized Banks dealers.
2.
Banks also recommends replacing
your transmission fluid, transmission
fluid filter, and transmission pan
gasket. Failure to service transmission
fluid may result in torque converter
damage.
Banks Billet Torque
Converter is designed for
a 6-stud, Ford 7.3L diesel
applications
You can verify the number of studs
on your existing torque converter by
removing the inspection cover on
the lower-front of the transmission
and counting the studs on the torque
converter (see Step 13 in installation
procedure).
96772 v.6.0
5